- Mac terminal emulator 9600 baud serial#
- Mac terminal emulator 9600 baud drivers#
- Mac terminal emulator 9600 baud software#
- Mac terminal emulator 9600 baud Pc#
When connected, press enter or type en to access the command prompt. Note if xon/xoff flow control does not work, use no flow control. Use the following settings for the terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control. Set up a terminal emulator to communicate with the access point.
Mac terminal emulator 9600 baud serial#
The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200.
Mac terminal emulator 9600 baud Pc#
If you need to configure the access point locally (without connecting the access point to a wired LAN), you can connect a PC to its console port using a DB-9 to RJ-45 serial cable.įollow these steps to open the CLI by connecting to the access point console port:Ĭonnect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial port on the access point and to the COM port on a computer. but there are no programs or data files on the Compact Flash card.Connecting to the 1200, 1230, 1240, and 1250 Series Access Points Locally You should now be able to start CP/M with the Small Computer Monitor command “CPM”.ĬP/M is now installed. Run the app in the same way as Format, with the command “G 8000”. Use the “Send file” feature again, but this time select the appropriate PutSys app. The appropriate file is available either in the Small Computer Workshop download or on the appropriate product page of this website.
Mac terminal emulator 9600 baud drivers#
The installation App includes CP/M device drivers and therefore must match the target hardware. The Compact Flash card is now ready to store files. If you are sure you want to format the Compact Flash card, press the “Y” key. The Small Computer Monitor command “G” is short for “Go” and the “8000” is the start address of the app. To run the Format app, type the command “G 8000”. The terminal window should then show “Ready” indicating the Format app has been sent to the retro computer system. Locate and open the Format app (download link above). Select Tera Term’s “Send file” option from the File menu. You require the following Small Computer Monitor App to format a Compact Flash card. The terminal window should show something like this: Formatting the Compact Flash cardīefore writing files to a Compact Flash card it must be formatted. The other settings are not critical.Ĭonnect the Z80 family retro computer system to the appropriate serial port and reset it.
Select “Terminal” from the Setup menu and ensure New-line is set to CR, and Local echo off. Systems using a 9600 baud bit-bang serial port, such as SC114’s built-in port, should be set to 9600baud, 8 data bits, 1 stop bit, no parity, hardware flow control enabled.
Mac terminal emulator 9600 baud software#
Most systems require the terminal emulation software to be set to 115200 baud, 8 data bits, 1 stop bit, no parity, no hardware flow control. Select “Serial port” from the Setup menu. The following instructions assume the use of Tera Term v4.96 and is illustrated here running on Windows 10. PutSysPlus is a Small Computer Monitor App which installs CP/M to a Compact Flash card. Other documentation and methods can be found here: Below is one method of installing CP/M 2.2 on to a Compact Flash card using the PutSysPlus utility.
0 kommentar(er)
